Checking oil level in automatic transmission and adding oil

Download TRANSMISSION 722.700 in MODEL 168.031 /032 /033 /131 /132 /133 TRANSMISSION 722.701 in MODEL 168.006 /007 /008 /009 /109 TRANSMISSION 722.702 in MODEL 168.035 /135 TRANSMISSION 722.750 /751 in MODEL 414.700. Adding transmission oil Risk of accident. Secure vehicle to prevent it from moving. AS00.00-Z-0005-01A Danger! Accidents may result if the vehicle starts off unintentionally with the Wear closed and snug-fitting work clothes. engine running. Risk of injury. Do not grasp hot or rotating parts. Crushing and burn injuries may result while working on engine during when it is being started or when it is in operation. 1 Remove locking pin (1) To do this, break off the plate on the locking pin using a suitable tool and press out the remaining pin in the cap downwards 2 Remove cap (2) 3 Fill with transmission oil The vehicle must be horizontal. Transmission oil (ATF) in accordance with BB00.40-P-0236-10A Specifications for Operating Fluids, sheet no. 236.10 *126589126300 *140589496300 *BF27.00-P-1001-01C When filling for the first time add only approx. 5.5 liters of transmission oil, and after an oil change approx. 4.0 liters of transmission oil, before starting the engine 4 Start engine and allow to idle in selector When refilling, top up with the rest of the lever position “P” specified quantity of oil Checking oil leveland correcting if necessary 5 Warm up transmission and shift through all After warming up the transmission, wait gears in “D” while warming up at least 2 minutes and check the oil level with the engine running in selector lever position P or N 6 Check transmission oil temperature Apply the service brake When the transmission is cold, the oil level indicator must be between the marks 2 and 4, 30° C (transmission oil temperature). The exact oil level must be between the marks 8 and 12 at 70°C to 80°C (transmission oil temperature) Model 168 Use the HHT to call up the current transmission oil temperature in one of the selector lever positions P, R, N or D Connect STAR DIAGNOSIS AD00.00-P-2000-04A Model 414 Diagnosis system STAR DIAGNOSIS *WH58.30-Z-1048-13A 7 Insert oil dipstick as far as the stop and pull out again, read off oil level and repeat if necessary *168589012100 If too much transmission oil is added, it is absolutely essential to drain off or extract the surplus. An insufficient or excessive oil quantity causes malfunctions and transmission damage. *210589007100 8 Check oil level again Correct, if necessary 9 Fit cap (2) on oil filler pipe and press in new locking pin (1) until it locks in position 10 Check transmission for leaks If there is a loss of oil, determine and eliminate the cause. Automatic transmission